Rebuilding a Worn Part for a 1930s Elevator Limit Switch

Almost nothing was left of the eccentric lifter in a 1930s elevator limit switch. We rebuilt it from micarta around the piece that survived.
Parts of a 1930s elevator limit switch, with the worn eccentric lifter and the maker's plate

A customer wanted the limit switch from a 1930s elevator restored, not replaced. The part that does the work in this switch is the eccentric lifter. It lifts the two copper arms that open and close the circuit. Ours had almost completely worn away, and only a small piece of the original was left.

The job

Part
Eccentric lifter
Equipment
1930s elevator limit switch
Problem
Original part almost completely deteriorated
Material
Micarta
Work
Rebuilt around the surviving piece

Parts of a 1930s elevator limit switch, with the worn eccentric lifter and the maker's plate

Working out the original shape

We worked out what the original lifter looked like from the piece that was left, then built the new part around it.

How we rebuilt it

  • Machined two pieces of micarta to shape.
  • Glued them together around the surviving piece of the original.
  • Secured the new part with flat head plastic screws.
  • Machined it again to bring it back to the original profile.

Eccentric lifter clamped in a milling vise for reconstruction

Worn eccentric lifter from a 1930s elevator limit switch, held above its nameplate

Have a part nobody makes anymore?

Send a photo and a few measurements. I'll tell you whether we can repair or make it, and roughly what it takes.

This site uses cookies

We use cookies to personalize your experience on this website. For more information, view our Privacy Policy.